New Miracle Detail Studio/Paintshop - Lambo Spyder

Discussion in 'Show and Shine' started by Paul Dalton aka Miracle, Feb 9, 2009.

  1. Paul Dalton aka Miracle

    Paul Dalton aka Miracle DB Pro Supporter

    Thanks Phil!!!
     
  2. VehicleDetail

    VehicleDetail Any Rag Vehicle Washer

    Congrats on the new premises Paul!

    Amazing work on the Lambo! Its nice to have a decent place to work and all the gear.

    How did you get on with the chip?
     
  3. David Fermani

    David Fermani DB Certified Manufacturer

    Paul - Beutiful vehicles.

    You mentioned this was 3 stage paint, but I was under the impression that it's actually 4 stage (they use a tinted clear)? Is there a reason why the right tail light wasn't removed or the right coner of the rear bumper dropped to avoid a hard line due to the joint being too tight. Did you clear the entire 1/4 panel along with the rocker panel or did you break it off at the lower edge of the 1/4?
     
  4. Wendell inc.

    Wendell inc. Birth of a Detailer

    Congrats Paul! So you have now started a body shop along with detailing?

    Also, it looks like your 'paint booth' is pretty open air. Aren't you worried about that?
     
  5. Racer

    Racer Birth of a Detailer

    Superb work Paul, all the luck with your STUDIO :thumb::thumb::thumb:
     
  6. DetailnDude

    DetailnDude Birth of a Detailer

    That is truly impressive ! I enjoyed viewing your work and shop ! I'll keep plugging away and hopefully someday.........
    :worship2:
     
  7. Paul Dalton aka Miracle

    Paul Dalton aka Miracle DB Pro Supporter

    Yes, sorry 4 stages, I always think of it as 3 stages, 2 layers of primer, 2 layers of base colour and 4 layers of clear coat 2 of them being the tinted clear and 2 normal clear.

    Only about 3 - 4 inches where sprayed, just the top bit where the stone chip was. No need to spray the whole panel.
     
  8. Paul Dalton aka Miracle

    Paul Dalton aka Miracle DB Pro Supporter

Share This Page