(adams) Detail Spray. Is This Normal?

Discussion in 'Last Steps: Waxes, Sealants, and Coatings' started by trhland, Aug 17, 2008.

  1. trhland

    trhland Nuba Guru

    i noticed after picking up my gallon on the bottom of the container it looked dirty. but it wasnt . it was in the container . is this just settelment from the q/d . once i shook it up it was gone. hmmm.
     
  2. Reflect

    Reflect DB Forum Supporter

    Can't really say anything about the Adams QD, but I know a few products tend to seperate when they sit, such as CG Citrus Wash and Gloss.
     
  3. heatgain

    heatgain Guest

    I see separation in my OCW gallon when it sits for oh, 20 minutes. That's why I shake EVERY product before use and even in-between sprays.
     
  4. trhland

    trhland Nuba Guru

    thanks guys . i quess its normal . it seems to be working ok ...
     
  5. P1et

    P1et Official DB Moderator

    Shake it up a bit and you should be good!
     
  6. reefer_bob

    reefer_bob Obsessive Detailer

    I have a 5 gallon, and I've never seen any seperation...
     
  7. trhland

    trhland Nuba Guru

    heres a pic of residue

    [​IMG]
     
  8. trhland

    trhland Nuba Guru

    i called (adams) spoke with some girl in custamer service told her and she says it should be fine. she did say is the spray working ok? and i said yes!! she was very nice and said any problems at all!!! call her back and they will take care of it no problem!! says alot about there company ..
     
  9. brianja

    brianja Jedi Nuba

    I have seen the same in mine.

    A quick shake usually takes care of it.
     
  10. trhland

    trhland Nuba Guru

    thanks!!!
     

Share This Page