I did this car about 5 months ago. Owner brought it back to me because concrete got on it somehow. I forgot to take before pictures of the concrete, but I can get them from the owner later. Said do whatever needs to be done, but focus on the concrete. Well, it needed a lot of paint correction too. Didnt do the interior this time. Didnt have my SLR with me, so I had to use a P&S. Products Used Edge Schmitt CG WnG P21s Wheel Gel Amazing Roll Off CG VRT EZ Brush Mothers Fenderwell Brush 4* clay Back- Set PakShak towels LC pads Metabo Menzerna SIP & 106FF (tried 106FA but the temperature in the garage was too low for it to break down right) CG JS Lusso Oro Before 12 cyl. 6L twin turbo 552hp Sorry, no after pictures of engine bay. After Level of correction on the car. The concrete was located on the right rear panel and a little on the right side of the rear bumper. Sorry for the shitty picture. I didnt like the look of Oro topped on CG JS. But it comes off easy as anything. Will have to try it by itself next time.
Don't put anything under Lusso its not going to work right. Try it again without the Jetseal. Nice Work.
Yeah, looked like it dulled the paint a little. Didnt like it at all. Will definitely try it by itself next time.
Does it bother anyone else that someone could onw a car such as this and have the paint looking that bad? The aftershots look as if it rolled out of the showroom......good job!
What shitty picture? The pictures look good. I can't believe how many swirls were on that paint. Poor Bentley .
All I can say about Oro right now is that it goes on and off super easy. I need to try it again by itself.
One of my clients has a silversky blue GTC....I second the comment that they are nice paint jobs but my guy only gets his car washed by me from new so thankfully I've never seen that bad of paint on it! poor bentley is right! GREAT WORK!
