The BEST wheel-well brush - In my opinion :-)

The challenge has always been getting a brush into the narrow opening between the tire and fender-well.


I have a cabinet full of tested and failed wheel-well brushes. Every available commercial brush - Including, the most resent suggestion, toilet-bowl brushes.


Until now, I have been using the Speed-Master - With the unfortunate negative side-effect of scuffing. See attachment.


Then, there is my newest pick… The cobweb duster-brush! No scratching, with the added benefit of an easy reach to the back of the tire.

 

Thanks a million for this! Been looking for a great tool to get fenders for a while!

 

If you want to upgrade from the $5.00 home-center brush to a fuller-head brush... See attachment. Then, if you are concerned about scratching the outside of the wheel-well... Use a pipe-wrap.

 

Can you clarify what you use as the handle? Link?

Thanks!

 

I used the first brush-head with an existing screw-on multi-use handle... At times it would come un-screwed. But as an inexpensive experiment... It was a success.

Then I did some research and found the attached. This head is much fuller; And the handle is a multi-use snap-on. Which resolved the first test setup.

Also, with the new set-up there is no need for the foam-sleeve.

Does this help?