Need good bodyshop in NY/CT area

Discussion in 'Detailing Bliss Lounge' started by newbie001, Jun 12, 2012.

  1. newbie001

    newbie001 Birth of a Detailer

  2. detailersdomain

    detailersdomain Administrator

  3. tfish1

    tfish1 Birth of a Detailer

    Gravels autobody in waterbury ct tell them tony sent ya
     
  4. newbie001

    newbie001 Birth of a Detailer

    Thanks Phil. Yeah, I would absolutely use them (you recommended them to me in the past) but they are a pain to get to from White Plains, NY. Then again if I just have it brought on a flat-bed (even though it is driveable) then I don't really care how far it is. So I'll see if bringing it on a flat bed will be covered even though it's driveable.

    Thanks. That's also a little farther from White Plains than I was hoping to go.


    My bad, forgot to mention that I'd like to stay somewhere close to White Plains, maybe a 30-45 minute radius. FTC does barely fit that (but it requires a trip over the GW or TZ bridge). But if it can be on a flat bed then I don't really care about that...
     
  5. GDAL

    GDAL Super Moderator

    My dad has used the recommended bodyshop for Yonkers Honda and they did an awesome work on his rear bumper replacement. Metallic flake was a 99% match and matched factory orange peel (minimal on bumper). I was impressed by their work specially for a Honda. I can try to get the info from my dad later today. I think the bodyshop is in Central Ave.
     
  6. newbie001

    newbie001 Birth of a Detailer

    Thank you.

    Also, has anyone used Island Park Auto Body in Port Chester? That's who my Audi dealer recommends (not sure if that's a good thing or a bad thing, but he did say they are Audi certified).
     
  7. nymisano

    nymisano Virgin Detailer

    Numme in Port Chester. I can for sure say stay clear of Pray, they are horrible.
     
  8. newbie001

    newbie001 Birth of a Detailer

    Oh man. I had actually narrowed it down to Pray. I spoke to them on the phone and they were very nice, they are Audi approved, and my insurance broker happens to have worked with them and never had any issues.

    Can you be more specific why you don't like them?

    Thanks again.
     
  9. nymisano

    nymisano Virgin Detailer

    I saw the job they did on my dads Audi A8. He backed the car into a dumpster and they had to mend in part of the rear quarter as it was an aluminum body. The roof and rear quarters I believe were one piece so couldnt just replace the quarter panel. You could clearly see the mend line, in daylight and any light. I am very picky, but this job would be subpar for even an average person. The paint was a very poor match as well. At the time they were the only shop in the northeast authorized by Audi to work on aluminum cars so there was no choice who to use.
     
  10. newbie001

    newbie001 Birth of a Detailer

    Thanks for the info. I'll definitely take it into consideration.
     
  11. newbie001

    newbie001 Birth of a Detailer

    Can you also tell me more about Numme? They do have some good reviews online and may give them a shot.
     
  12. nymisano

    nymisano Virgin Detailer

    Ive seen good work out of there, owner cares about making the customer happy. My car goes there in a few weeks for rear bumper re-spray.
     
  13. newbie001

    newbie001 Birth of a Detailer

    Thanks. I think I'm going to go with them as it's very convenient for me to get to as well.
     

Share This Page